Bond strength of conventional, subtractive, and additive manufactured denture bases to soft and hard relining materials was written by Wemken, Gregor;Burkhardt, Felix;Spies, Benedikt Christopher;Kleinvogel, Laura;Adali, Ufuk;Sterzenbach, Guido;Beuer, Florian;Wesemann, Christian. And the article was included in Dental Materials in 2021.Application of 5137-55-3 The following contents are mentioned in the article:
To investigate the tensile and flexural strength of poured, subtractive, and additive manufactured denture base methacrylates bonded to soft and hard relining materials after hydrothermal cycling and microwave irradiation This study included a conventional (CB), subtractive (SB), and additive (AB) base material as well as a soft (SCR) and hard (HCR) chairside and one hard laboratory-side (HLR) relining material. Reference bodies of the base materials and bonded specimens to the relining materials were produced with a rectangular cross-section. The specimens were either pre-treated by water storage (50 h, 37 °C), hydrothermal cycling (5000 cycles, 5 °C and 55 °C, 30 s each), or microwave irradiation (6 cycles, 640 W, 3 min, wet). A tensile and four-point bending test were performed for a total of 504 specimens. Data were analyzed using multivariate anal. of variance (MANOVA) with post-hoc Tukey tests (α = 0.05). In comparison with the other reference groups SB showed marginally higher tensile and flexural strength (p < 0.047). Bond strength to SCR was affected neither by the base material nor by the pre-treatment (p > 0.085). HCR demonstrated twice the bond strength to AB compared with SB and CB (p ≤ 0.001). HLR showed the highest bond strength to CB (p ≤ 0.001). There was no difference between the specimens after hydrothermally cycling and microwave irradiation (p > 0.318). The bond strength of hard relining materials to subtractive and additive manufactured denture bases differ compared with conventional pouring. This study involved multiple reactions and reactants, such as N-Methyl-N,N-dioctyloctan-1-aminium chloride (cas: 5137-55-3Application of 5137-55-3).
N-Methyl-N,N-dioctyloctan-1-aminium chloride (cas: 5137-55-3) belongs to organic chlorides. Organic chlorides can cause corrosion in pipelines, valves and condensers, and cause catalyst poisoning. The hydrocarbon processing industry (HPI) and others are affected by damage caused by these substances. Alkanes and aryl alkanes may be chlorinated under free radical conditions, with UV light. However, the extent of chlorination is difficult to control.Application of 5137-55-3
Referemce:
Chloride – Wikipedia,
Chlorides – an overview | ScienceDirect Topics